External primer for Acrylic basecoats 20kg

Polstyr Silicone Primer is a water-dilluting priming emulsion designed to strengthen and reduce the absorbency of the substrate and improve the adhesion of silicone plasters. It is part of the POLSTYR insulation system and works perfectly both inside and outside buildings.
POLSTYR PRIMAZONE S is part of the POLSTYR insulation system. It is a water-dillutable priming emulsion with the addition of selected aggregates intended to strengthen and reduce the absorbency of the substrate and improve the adhesion of POLSTYR silicone plaster. For use inside and outside, for priming the reinforcing layer in the POLSTYR insulation system. It facilitates application and increases the efficiency of the plaster mass. Prevents the transfer of contamination from the base layers to the plaster. After additional coloring, it pre-colors the substrate.
The primer is ready to use – it does not require dilution. Before use, mix the contents of the package thoroughly until a uniform consistency is obtained. If necessary, dilute with a small amount of clean water (maximum 1% of the package volume) and mix again. The amount of water added should be the same for each package. Apply the product evenly to the surface using a brush or roller. Apply the plaster mass after the primed surface has dried for at least 24 hours. The priming process should take place at an air, substrate and product temperature of +5ºC to +25ºC. Protect freshly applied coatings from rain, frost, direct sunlight and strong wind. Use special covers to limit the adverse effects of weather conditions. Immediately wash off any accidental dirt with plenty of water. Wash tools with water immediately after use.
Packaging: 10 kg or 20 kg bucket 
Product consumption: 0.25 kg/m² 
Diffusion ability: Yes 
Water-dillutable: Yes